Skip to product information
1 of 5
BIKEMAN PERFORMANCE

PERFORMANCE STG3 KIT / PRO R 300hp

PERFORMANCE STG3 KIT / PRO R 300hp

Regular price $2,899.95 USD
Regular price Sale price $2,899.95 USD
Sale Sold out
Choose Exhaust
Choose Heat Shield (Side Exit Only)
Choose Haet Shield Backer (Side Exit Only)

PERFORMANCE STG3 KIT / PRO R 300hp

This is the most popular Performance upgrade kit for the Polaris Pro R RZR. Our custom cams offer the best price per horse power. These performance camshafts had 9 revisions before we released them to the market. Our optimized lobe duration maximizes air and fuel to enter the engine to maximize combustion. This modification brings no added wear and tear to the motor and is just as safe as a stock camshaft. Paired with out exhaust and tune you get a whopping 300 crank hp.

  • .430 LIFT  DROP IN CAMS
  • Bikeman CUSTOM SPEC FROM BRIAN CROWER
  • INSTANT THROTTLE RESPONSE
  • LOW END GRUNT AND TOP END PULL WITH THE CAMS
  • OUR PERFORMANCE CLUTCH SPRINGS HOLD MUCH BETTER BELT TENSION THEN FACTORY. CLUTCHING ADJUSTS TO ANY TERRAIN 
  • MORE RESPONSIVE FEEL
  • CYCLONE CLUTCH COVER FOR EVEN COOLER BELT TEMPS AND LONGER BELT AND CLUTCH LIFE  
  • GAINS TOP SPEED AND LOW END POWER
  • THESE CAMS ARE SPECIFIC TO US AND NONE ELSE CAN BUY THIS SAME CAM PROFILE. BRAND NEW CORES NOT A REGRIND CAMSHAFT
  • MUST SEND IN ECU FOR HARD FLASH 

INCLUDED IN KIT:

SLIP ON EXHAUST 

SNYPR Stage 1 Clutch kit

Cyclone Clutch Cover

ECU HARD FLASH

Custom BMP .430 Lift Cams

Pro R HP ratings-
Stock 230-235hp@8400rpm 
 
Stage 3 ,
Level 3 ECU tune, BMP .430 lift cams and BMP slip on muffler 298hp@8775rpm / 194TQ@7525

Steps for starting your Pro R stage 3 and above for the first time after a ECU Flash.
*** These steps are different than the service manual. Do not follow service manual steps ***

1. Roll the engine over by hand at least 10 revolutions clockwise when looking at it from the rear.
2. Check Cam timing to make sure it is correct
3. Make sure coolant and oil is at the correct level.
4. Start the engine and hold above 2000rpm until it reaches 170 degrees F.
5. Using the throttle drop rpm 50 rpm per 30 seconds until idle seems unstable. 
6. Stay at the unstable rpm until it becomes stable and then repeat step 5.
7. Once the machine is idling at 1450 stable with no throttle input let sit and idle for 10-15 minutes.
8. Your machine is now ready to ride.
9. On higher duration cams it is common to need to give a little throttle to start the vehicle this is completely normal.

VEHICLE FITMENT:

• POLARIS RZR PRO R

⚠ California Proposition 65 Warning ⚠ This product may contain a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.

View full details